PUP D-One

Powered Up Drive One

PUP D-One allows you to control your Lego Powered-Up train (both A and B ports) using your Android device (smartphone or tablet).

You can save up to 9 different trains.

Each time you connect a new train, follow this procedure:

- switch on the device bluetooth and the train bluetooth;

- in the "setting" menu tap on the SCAN button. The app will identify the Bluetooth Address of the train. Save it and rename the train if you want.

For driving the train:

- switch on the device bluetooth and the train bluetooth;

- in the "connection" menu tap on the SCAN button. When the connection bar becomes yellow, tap on the CONNECT button. When the connection is established, the connection bar becomes green and the train light is on.

- select the "drive" menu.

- drive & enjoy!

Setting page buttons:

SAVE: save the displayed configuration (overwriting the eventual modified fields)

ADD: add a new configuration (the displayed configuration will be duplicated)

DELETE: remove the displayed configuration

RESET: restore the factory configuration (the BLE address will need to set again)

SCAN: identify the BLE address of the train

Connection page buttons:

SCAN: find the active train (the BLE address must be alredy saved in the setting page and the train must be selected in the connection page)

CONNECT: connect to the detected train

DISCONNECT: disconnect

LEFT/RIGHT ARROW: select the train configuration saved in the setting page

Drive page buttons:

LAMP: switch the lamp on/off (if connected in the B port)

LEFT ARROW: increase/decrease the speed according to the train direction

STOP: stop the train

RECYCLE ARROWS:

RIGHT ARROW: increase/decrease the speed according to the train direction

LIGHTING: reverse the direction of the speed buttons

Requirements: Android device with Bluetooth LE.

Disclaimer: the LEGO Group doesn't sponsor, authorize or endorse this app.